Alzola, Rafael Pena1; Liserre, Marco1; Blaabjerg, Frede3; Sebastián, Rafael4; Dannehl, Jörg5; Wilhelm Fuchs, Friedrich6
1 The Faculty of Engineering and Science (ENG), Aalborg University, VBN2 Department of Energy Technology, The Faculty of Engineering and Science, Aalborg University, VBN3 Power Electronic Systems, The Faculty of Engineering and Science, Aalborg University, VBN4 Department of Electrical, Electronic and Control Engineering, National University for Distance Learning, Madrid5 Danfoss Solar Inverters, Sønderborg6 Institute for Power Electronics and Electrical Drives, Christian-Albrechts-University of Kiel
Three-phase active rectifiers guarantee sinusoidal input currents and unity power factor at the price of a high switching frequency ripple. To adopt an LCL-filter, instead of an L-filter, allows using reduced values for the inductances and so preserving dynamics. However, stability problems can arise in the current control loop if the present resonance is not properly damped. Passive damping simply adds resistors in series with the LCL-filter capacitors. This simplicity is at the expense of increased losses and encumbrances. Active damping modifies the control algorithm to attain stability without using dissipative elements but, sometimes, needing additional sensors. This solution has been addressed in many publications. The lead-lag network method is one of the first reported procedures and continues being in use. However, neither there is a direct tuning procedure (without trial and error) nor its rationale has been explained. Thus, in this paper a straightforward procedure is developed to tune the lead-lag network with the help of software tools. The rationale of this procedure, based on the capacitor current feedback, is elucidated. Stability is studied by means of the root locus analysis in z-plane. Selecting the lead-lag network for the maximum damping in the closed-loop poles uses a simple optimization algorithm. The robustness against the grid inductance variation is also analyzed. Simulations and experiments confirm the validity of the proposed design flow.
I E E E Transactions on Industrial Informatics, 2014, Vol 10, Issue 1, p. 43-52
Active damping; LCL-filter; Lead-lag; Rectifier; Stability; Voltage-source converter