Lee, Jae Hwan3; Natarajan, Balakumaran7; Eun, Won Jong7; Viswamurthy, S. R.5; Park, Jae-Sang6; Kim, Taeseong1; Shin, Sang Joon7
1 Department of Wind Energy, Technical University of Denmark2 Aeroelastic Design, Department of Wind Energy, Technical University of Denmark3 Samsung Techwin R&D Center4 Seoul National University5 National Aerospace Laboratories6 Agency for Defense Development7 Seoul National University
A conventional rotor control system restricted at 1/rev frequency component is unable to vary the hub vibratory loads and the aeroacoustic noise, which exist in high frequency components. Various active rotor control methodologies have been examined in the literature to alleviate the problem of excessive hub vibratory loads and noise. The active control device manipulates the blade pitch angle with arbitrary higher harmonic frequencies individually. In this paper, an active trailing-edge flap blade, which is one of the active control methods, is developed to reduce vibratory loads and noise of the rotor through modification of unsteady aerodynamic loads. Piezoelectric actuators installed inside the blade manipulate the motion of the trailing edge flap. The proposed blade rotates at higher speed and additional structures are included to support the actuators and the flap. This improves the design, as the blade is able to withstand increased centrifugal force. The cross-section of the active blade is designed first. A stress/strain recovery analysis is then conducted to verify its structural integrity. A one-dimensional beam analysis is also carried out to assist with the construction of the fan diagram. To select the actuator and design the flap actuation region, the flap hinge moment is estimated via a CFD analysis. To obtain the desired flap deflection of ±4°, three actuators are required. The design of the flap actuation region is validated using a test bed with a skin hinge. However, because the skin hinge induces additional flap hinge moment, it does not provide sufficient deflection angle. Therefore, the flap hinge is replaced by a pin-type hinge, and the results are evaluated.
Journal of Mechanical Science and Technology, 2013, Vol 27, Issue 9, p. 2605-2617
Active trailing-edge flap; Piezoelectric actuator; Active rotor blade design; Structural integrity