1 Department of Energy Technology, The Faculty of Engineering and Science, Aalborg University, VBN2 Power Electronic Systems, The Faculty of Engineering and Science, Aalborg University, VBN3 The Faculty of Engineering and Science (ENG), Aalborg University, VBN4 Technical University of Catalonia
Ancillary services for distributed generation systems become a challenging issue to smartly integrate renewable energy sources into the grid. Voltage control is one of these ancillary services which can ride through and support the voltage under grid faults. Grid codes from the Transmission System Operators describe the behavior of the energy source, regulating voltage limits and reactive power injection to remain connected and support the grid under fault. On the basis that different kinds of voltage sags require different voltage support strategies, a flexible control scheme for three phase grid connected inverters is proposed. In three phase balanced voltage sags, the inverter should inject reactive power in order to raise the voltage in all phases. In one or two phase faults, the main concern of the distributed generation inverter is to equalize voltages by reducing the negative symmetric sequence and clear the phase jump. Due to system limitations, a balance between these two extreme policies is mandatory. Thus, over-voltage and undervoltage can be avoided, and the proposed control scheme prevents disconnection while achieving the desired voltage support service. The main contribution of this work is the introduction of a control algorithm for reference current generation that provides flexible voltage support under grid faults. Two different voltage sags have been experimentally tested to illustrate the behavior of the proposed voltage support control scheme.
I E E E Transactions on Industrial Electronics, 2013, Vol 60, Issue 4, p. 1429-1441
Reactive power control; Voltage ride through; Voltage sag; Voltage support