1 Test and Measurements, Wind Energy Division, Risø National Laboratory for Sustainable Energy, Technical University of Denmark2 Wind Energy Division, Risø National Laboratory for Sustainable Energy, Technical University of Denmark3 Risø National Laboratory for Sustainable Energy, Technical University of Denmark4 Department of Wind Energy, Technical University of Denmark
Work Package 1B.2 under the European Commission, Integrated Wind Turbine Design (UPWIND)
The present report is the final effort of tasks carried out under UPWIND WP1B2 transmission and conversion, which describes: 1) results and recommendations developed in the course of developing the long-term load measurement technique 2) the hardware details, type of sensors and location, data storage and 3) data analysis technique to verify design load assumptions. The work is carried out under Contract no 019945 (SES6) "UPWIND" within the European Commission The interaction between the mechanical and electrical generator subsystems is described rudimentarily, based primarily on HAWC2 simulations below stall of the mechanical system with simple generator and gearbox systems. The electrical system simulations were not carried out as intended in DOW, but indications of the conditions for establishing the interaction have been described by measurements and by argument, that this might have an effect as indicated. The hypothesis stating, that the power signal can be utilized as a basic signal for extended analysis of mechanical as well as electrical power signal with static and dynamic features, has been demonstrated on performance and dynamic bandwidth capability. It is however from present analysis obvious that improved signal conditions could be achieved with other mechanical joint solutions than with the present torque signal as measured with the cardan joint. For the reasons mentioned, the comparison with a signal showing the mechanical properties could be improved, with a likely gain on the accuracy as a result.